Foam: Total War
March 29, 2024, 12:19:33 am
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: See Announcements
 
  Home Help Search Links Staff List Members Login Register  

Double Shot

Pages: [1]
  Print  
Author Topic: Double Shot  (Read 456 times)
0 Members and 1 Guest are viewing this topic.
Sarge
Spartan-117
Administrator
Sr. Member
*****
Offline Offline

Posts: 276


Hoo-rah!


View Profile WWW
« on: July 26, 2007, 03:48:07 pm »

This modification is courtesy of General Cole. Thanks GC!



All previous DS mods use CPVC modded shells. This mod lets you save those dumb shells for your RFR and Mustang 6.  Thats right a DS mod that doesn't use shells.  Now on to how you do it.

Materials-
Hot Glue
Hot Glue Gun
E-Tape
DoubleShot
Hacksaw
Dremel
1/2in Thinwall PVC
1/2in CPVC
Pliars (Optional, it will save your fingers)
File (Optional, if you can't cut straight)
PVC Cutters

How To-
Take your DS.  Open the Gun up, not with a screw driver, open it to see where you load the shells.  Take your Dremel and start cutting on the orange ring that you push the shell into.  Cut where that little protrusion is.  You should be able to pull it out eventually, try not to damage the outside of the gun during this.  Here is what the removed orange piece looks like-



Then take your pliars or fingers and stretch the spring out as far as you can.  Here is a pic with one removed and one in progress-



Then take it and pull it to the right for the right barrel and to the left for the left barrel.  Try to pull it through the seam.  The end of the wire has a little bend so just pull like crazy until it comes out.



Now take the gun to a place where you can manuver pipe in it.  Now take your thinwall 1/2in pipe and insert it into where the springs and orange ring were.  It should be about 3in.  Mark that with a sharpie and cut it out using the pipe cutters.  Do this twice.



Then cut 2 3in sections of the CPVC and wrap it in E-Tape in two places until it is tight in the thinwall pipe.



Insert the CPVC into the thinwall and make it as flush as possible.  If it isn't close to flush the gun will be hard to flip up.  Now seal the ends with a small bead of hotglue, don't let it protrude out much.



Then insert it into where the shells used to go, no need to hot glue it there.  If you are in need of a challenge then try to open it up and give the strings one twist, then you don't have to open it as far to fully **** it.  Then hacksaw off the front just in front of the handgrip.  I glued mine on top of the actual barrel because I find it easier to hold.



Hopefully this helped!
 
 
 
Report Spam   Logged

Share on Facebook Share on Twitter

Megamannt92
Administrator
Full Member
*****
Offline Offline

Posts: 209


View Profile WWW
« Reply #1 on: August 04, 2007, 08:09:10 am »

Just as good of a mod here as it was back at FU. Best DS mod on the net.
Report Spam   Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by WebRing.
Bookmark this site! | Upgrade This Forum
SMF For Free - Create your own Forum

Powered by SMF | SMF © 2016, Simple Machines
Privacy Policy