|
Title: CPVC Magstrike Modification Post by: Megamannt92 on August 04, 2007, 08:14:25 am Mag-Strike Clip Modification (CPVC)
Putting PVC in your Mag clips drastically increases the overall range and power of your Magstrike. What you will need: -Pair of needlenose plyers -Butter knife -Hot glue/Hot glue gun -Flat screwdriver -Sandpaper(maybe if you mess up) -Hammer -Pipecutter/Hacksaw -CPVC Pipe (http://i87.photobucket.com/albums/k121/Megamannt92/ARremoval.jpg) OK lets get started. Pick up your clip, take your plyers, pull out the AR sticks and then flip over the clip and bore out the other pieces of plastic in the back like so. Ok that was the obvious and easy part. (http://i87.photobucket.com/albums/k121/Megamannt92/pryhere.jpg) Now the PVC part. Ok turn your clip over and locate the small slit in the back (look at the pic) Take a butter knife and slide it under the piece carefully, don’t do it too fast otherwise you will break it(the plastic is very thin). All right now that is off you will see the bottom of the default barrels, flip it over to the top again now and use the flat screwdriver to separate the barrels from the side of the clip. Do it slowly and carefully if you break the outside of the clip it will be beyond help.....After that the barrels should come out rather easily.... Ok now you have a empty clip cut the CPVC pipes, you can make them a little longer than the original barrels. Now put the bottom flat piece that we removed earlier back on keep it pressed on a table so it stays even....Now hot glue the barrels in from the inside. There your done! (http://i87.photobucket.com/albums/k121/Megamannt92/MagMOd2.jpg) If for some reason the clip does not fit into the gun, sand the back of the clip until it fits into the gun. Title: Re: CPVC Magstrike Modification Post by: Sarge on August 23, 2007, 03:50:59 pm Good write up, this may help if I ever get a Magstrike. Thanks, Mega. -Sarge |